Completing the installation
Level the freezer so the door will close prop-
erly. The leveling legs are packaged with your
Use and Care Guide.
1.
Attach the 2 plastic legs to the right and left
front comers of the freezer base. Use 2
leveling screws.
2. Screw leveling screws into the right and left
rear corners of the freezer base.
3. Snap the plastic screw covers over the
heads of the rear leveling screws.
4. Connect the freezer to a proper electrical
supply. (See “Locating the proper electrical
supply on page 5.)
5. Slide the freezer into place.
6. Place a level on the top of the freezer- first
side-to-side, then front-to-back. Turn the
rear leveling screws clockwise to lower
them or counterclockwise to raise them.
NOTE: Adjust the freezer so the rear legs
are slightly lower than the front fixed legs.
This will help the door seal better.
7. After the freezer is filled with food, recheck
with a level.
Front plastic
leg and
leveling screw
Rear levellng
screw and
plastic cover
6
