Using the Radio’s Menus
37
4. If the base ID you set appears correctly, rotate PUSH/SELECT to select YES. The radio
saves the base ID you input. Otherwise, rotate PUSH/SELECT to select NO.
5. Turn the radio off then turn it back on to enable the base ID you set.
Setting a WHAM Link Channel
The link channel between the radio and the WHAM microphone you are installing must be
the same. You can select 20 link channels.
1. Rotate PUSH/SELECT to select LINK CH, then press PUSH/SELECT to select it. LINK
CH and a channel number appear.
2. Rotate PUSH/SELECT clockwise to move forward through the displayed numbers or
counterclockwise to move backward. When the number you want appears, press PUSH/
SELECT to select it. A confirmation screen appears.
3. If the channel number you set appears correctly, rotate PUSH/SELECT to select YES. The
radio saves the channel number you input. Otherwise, rotate PUSH/SELECT to select NO.
4. Turn the radio off then turn it back on to enable the base ID you set.
Setting a WHAM x 4 Base ID
The base ID between the radio and the WHAM x 4 microphone you are installing must be the same.
1. Rotate PUSH/SELECT to select BASE ID, then press PUSH/SELECT to select it. BASE
ID and a channel number appear.
2. Rotate PUSH/SELECT clockwise to move forward through the displayed numbers or
counterclockwise to move backward. When the number you want appears, press PUSH/
SELECT to select it. A confirmation screen appears.
3. If the base ID you set appears correctly, rotate PUSH/SELECT to select YES. The radio
saves the base ID you input. Otherwise, rotate PUSH/SELECT to select NO.
Setting the WHAM Sub Radio Mode
You can set up the radio so connected WHAM and WHAM x 4 microphones can
communicate with each other.
1. Rotate PUSH/SELECT to select SUB RADIO, then press PUSH/SELECT to select it.
SUB RADIO and ON and OFF appear.
2. To turn on the sub radio mode, rotate PUSH/SELECT to select ON, then press PUSH/
SELECT to confirm it. The sub radio mode is turned on.
Otherwise, to turn off the sub radio mode, rotate PUSH/SELECT to select OFF, then
press PUSH/SELECT to confirm it.
Setting the WHAM x 4 Antenna
You can select the antenna you want to use with the WHAM x 4 microphone.
1. Rotate PUSH/SELECT to select ANTENNA SEL, then press PUSH/SELECT to select it.
2. To select the internal WHAM x 4 antenna, rotate PUSH/SELECT to select INTERNAL,
then press PUSH/SELECT to confirm it. Otherwise, to select the external antenna, rotate
PUSH/SELECT to select EXTERNAL, then press PUSH/SELECT to confirm it.
