A SERVICE OF

logo

Open as PDF
next previous
Seal Protector (Fig. 7)
Slide the protector (Item 1) over the reel motor shaft
before installing the shaft seal to protect the seal from
damage. Apply a light coating of clean oil to the seal
protector to ease movement of the seal over the tools.
Use the installer (Item 2) and a small hammer to drive
the reel motor shaft seal into position in the bore of the
reel motor body.
Figure 7
Detent Installation Tool (Fig. 8)
Use this tool with a 3/8 in. drive torque wrench to tighten
the detent stud in the No. 1 spool of the control valve.
Apply Loctite 222 or equivalent to the threads of the
detent stud. Tighten the stud to a torque of 10 - 14 ft-lb.
Figure 8
Special Tools Page 4 - 14 Greensmaster
®
3100