Powering the Amplifier
Power Cord Connection
The ASAP3D SE features an IEC power
connector (see
Figure 3
). Plug the
female end of the power cord into the
Power Cord Connector on the amplifi-
er’s rear panel and plug the male end
into a grounded wall socket. Do NOT
plug the amplifier’s power cord into a
convenience outlet on any other audio
or video component. (Note: A power
cord is included only with the 120V
version of the amplifier.)
I
MPORTANT: DO NOT PLUG THE
POWER CORD INTO THE WALL OUTLET
UNTIL ALL SYSTEM CONNECTIONS HAVE BEEN MADE AND
VERIFIED.
N
OTE: IF YOU NEED TO USE AN EXTENSION CORD, USE ONLY A
HEAVY
-DUTY (16-GAUGE OR LARGER) EXTENSION CORD TO AVOID
STARVING THE AMPLIFIER OF ALL THE CURRENT NECESSARY FOR
FULL
-POWER OPERATION.
A.C. Fuse Holder
120V versions of the Sonamp ASAP3D
SE are shipped with a 2 amp AC fuse
installed. 230V versions have a 1.25
amp AC fuse installed. The fuse protects
the amplifier circuitry;
THE AC TRIGGER
OUTLET IS NOT PROTECTED BY THE FUSE.
To replace the fuse, unplug the power
cord from the Power Cord Connector
and use a screwdriver to remove the
fuse holder (see
Figure 4
).
CAUTION: FOR CONTINUED PROTECTION AGAINST
FIRE, REPLACE THE FUSE WITH ONLY THE SAME TYPE AND
RATING.
SONAMP
®
ASAP3D SE STEREO POWER AMPLIFIER
5
