16
Initial Installation
Secure Cables
DRILL REMOTE DEFLECTOR CONTROL MOUNTING
BRACKET HOLES
NOTE: Perform the following procedure after the
snowthrower is completely installed for the first time.
1. Using the template included in the back of this manu-
al, drill two 9/32” holes in the dashboard to mount the
remote deflector control bracket (C, Figure 21). See
template at the back of this book for instructions.
SECURE REMOTE DEFLECTOR CONTROL CABLE
NOTE: Perform the following procedure after the
snowthrower is completely installed for the first time.
1. Insert the deflector control handle (B, Figure 21) into
the mounting bracket (C).
2. Route the remote deflector control cable and spout
rotator motor wires through the cable guide (A, Figure
22).
3. Secure the handle (B, Figure 21) using a clevis pin
(A) and hair pin clip (D).
A
B
Attach Short Drive Shaft to Drive Box
1. Grease the drive shaft coupler and chain box input
shaft.
2. Install the key (A, Figure 20) into the input shaft key-
way.
3. Attach the drive shaft to the input shaft (see Figure
20).
4. Secure the drive shaft using a 1/4-20 x 1-7/8” cap-
screw (D, Figure 20) and center-lock nut (B).
NOTE: The 1/4-20 x 1-7/8 capscrew supplied in the
hardware bag has been ground to exactly 1-7/8 length
for this purpose and is required for correct drive shaft
clearance.
5. Secure the key with an hex socket set screw (C,
Figure 20).
C
SECURE SPOUT ROTATOR WIRE HARNESS
NOTE: Perform the following procedure after the
snowthrower is completely installed for the first time.
1. Secure the spout rotator wire harness to the remote
deflector control cable as shown in Figure 22 using
cable ties (C).
Connect Electric Chute Rotator
Wire Harness
1. Connect the electric discharge chute rotator motor
leads to the wire harness. Route the wire harness
through the control cable support arm (see Figure
22).
Figure 22. Deflector Control Cable Support Arm
A. Cable Guide C. Cable Ties
B. Holes in Snowthrower
A
B
D
B
B
C
D
Figure 20. Install Drive Shaft
A. Key C. Set Screw
B. Nut, Centerlock, 1/4-20 D. Capscrew, 1/4-20 x 1-7/8
Figure 21. Install Remote Deflector Control
A. Clevis Pin C. Mounting Bracket
B. Deflector Control Handle D. Hair Pin Clip
Side of
Snowthrower
A
C
