NOTE
Not all hardware supplied with horn kit will be used
for this installation. Discard excess hardware.
Refer to
figure 1 to familiarize yourself with the
assembly.
NOTE
On newer gear models, battery is not located in rear
compartment (see figure 3). This allows installation
by either of the following methods.
HORN INSTALLATION - Early Gear Models
1.
Install the two mounting plates (A, figure 2) together
and install onto the shift cable mounting bracket
using the
l/4
flange whizlock nut and l/4-20
x
5/8
capscrew (B).
2.,
Mount the horn by inserting it through the mounting,
plates (A) and installing lockwasher and nut (D).
Then, connect one end of the 45 inch black wire to,
either horn terminal (C).
Figure 2.
A. Mounting Plates
6.
capscrew
C. Terminal
D. Nut
3. Route the 45 inch wire along with other wires along
right-hand side of frame and under footrest (figure
3).
4. Go to HORN BUTTON INSTALLATION
-
All
Models.
Figure 3. Early Gear Models
A. Horn
B. Wire
HORN INSTALLATION - Hydra Models
1.
Connect the horn (A, figure 1) to the mounting plates
(L) with lockwasher (M) and nut (N).
2. Connect the L-bracket (P, figure 1) to the mounting
plates (L) with lockwasher (M) and nut (N).
3. Install the horn as shown in
figure 4 as follows.
a. Locate the existing screw and retainer under the
rear edge of footrest.
Figure 4. Hydra ModelsFigure 4. Hydra Models
A. HornA. Horn
B. Mounting StrapsB. Mounting Straps
C. WireC. Wire
D. TerminalD. Terminal
2
