3
XEA-201 Reset
There are 2 resets for the XEA-201. The first one is a basic “initialization” and the
second one is a master reset. The first steps below should always be done first before
the master reset.
The initial procedure is below. You should not lose your programming information doing
this reset.
• Unplug from the electrical outlet
• Wait over 1 minute for unit to discharge
• Put the register in PGM mode
• While holding down the “feed” key, plug in the unit.
If this procedure does not reset unit please try the following. *
• Make sure register is plugged in
• Put register in REG mode
• Take out the batteries
• Unplug the register from the electrical outlet
• Wait 1 minute for unit to discharge
•
Plug unit back in
*Note: This is considered the Master Reset and should reset the unit to factory settings.
XEA-401 reset
There are 2 resets for the XEA-401. The first one is a basic “initialization” and the
second one is a master reset. The first steps below should always be done first before
the master reset.
The first procedure is as follows: this should always be done first. You should not lose
your programming with this reset.
• Unplug the unit from the electrical outlet
• Set the mode switch to PGM position
• While holding down both “journal feed” key and “Receipt feed” key, plug unit back in.
If this procedure does not work, proceed with the Master Reset below.*
• Unplug unit from electrical outlet
• Set the mode switch to PGM mode
• While holding down both the “journal feed” key and the “CL” key, plug the unit back in.
* Note: This procedure is considered the Master Reset and should reset to factory settings
.
