ASSEMBLY
UNPACK CARTON & INSTALL HANDLE
(See Fig. 2)
I& CAUTION: Becarefulofexposedstaples
when handling or disposing of cartoning
material.
IMPORTANT: WHEN UNPACKING AND ASSEMBLING
TILLER, BE CAREFUL NOT TO STRETCH OR KINK
CABLE(S).
• Cut cable ties securing handles.
• Slowlylitt handleassembly up, routecable(s) as sbown
and align handle holes with handle panel hole and slot.
• Loosely assemble hardware as shown. Be sure the
shorter (3/4" long) hexbolt isassembled inlower holeof
handle. Repeatforoppositeside. Tightenallhardware
securely.
• Cut cable ties securing tiller to skid and remove tiller
from skid.
• Remove screws securing depth stake to skid and
discard the screws.
LOCK
NUT WASHER TILLER
HANDLE
HANDLE
PANEL
HEXBOLT
_16-18X1"
HEXBOLT
WASHER _1_18X_4"
TILLER
HANE
HANDLE
PANEL
BOLTS
INSTALL DEPTH STAKE ASSEMBLY
• Loosen nut"A".
Insert stake support between engine bracket halves with
stake spring down.
• Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tighten securely. Tighten nut =A".
Depth stake must move freely. If it does not, loosen
support bolt.
\
ENGINE BRACKET
NUT "A"
DEPTH
STAKE
BOLT
STAKE
SPRING
HEX BOLTS,
LOCK WASHERS,
AND HEX NUTS
FIG. 3
HANDLE HEIGHT
• Handle height may be adjusted to better suitoperator.
(Bee "HANDLE HEIGHT" in the Service and Adjust-
ments section of this manual).
TILLING WIDTH
• Tilling widthmaybe adjusted tobetter handleyourtilling
conditions (See WINE ARRANGEMENT" inthe Service
and Adjustments section of this manual).
TINE OPERATION
• Check tine operation before first use. (See "TINE
OPERATION CHECK" in theService and Adjustments
section of this manual).
RG. 2
5
