36
3139 115 23251
English
IMPORTANT!
Make sure the FM and MW
antennas are connected.
Tuning to radio stations
1
Press SOURCE control to select
“TUNER FM” or “TUNER MW”.
2 Press 34 briefly on the remote.
➜"SEARCH" appears.
➜The next radio station will tune
automatically.
3 Repeat step 2 if necessary until you find
the desired radio station.
4 To tune a weak station, press S / T
briefly and repeatedly until an optimal
reception is found.
● If the FM station reception is weak, you
can switch the FM mode from stereo to
mono. Press SURR button will toggle
through:
DOLBY PL II FM ST (stereo)
™ DOLBY PL II FM MONO
™ STEREO FM MONO
™ STEREO FM ST
Presetting radio stations
You can store up to 20 FM and 10 MW
preset radio stations in the memory.
Helpful Hints:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no valid frequency is detected during
Plug and Play,"CHECK ANTENNA" appears.
Using the Plug and Play
Plug and Play allows you to store all
available radio stations automatically.
1
2
AUTO INSTALL PRESS PLAY
1 For first time setup, press SOURCE
on front panel to select TUNER mode.
➜"AUTO INSTALL PRESS PLAY"
appears.
2 Press 2; on the top panel to start
installation.
➜"INSTALL TUNER" appears.
➜Once complete, the last tuned radio
station will play.
➜FM followed by MW bands will be
stored.
Tuner Operations
001-045-LX8320-69-Eng2 13/08/2004, 11:25 AM36
