IPv6 Commands
395
ProSafe M4100 and M7100 Managed Switches
maximum-paths (OSPFv3)
This command sets the number of paths that OSPF can report for a given destination where
maxpaths is platform-dependent.
Default
Format maximum-paths <maxpaths>
Mode
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back
to its default value.
Format no maximum-paths
Mode
passive-interface default (OSPFv3)
Use this command to enable global passive mode by default for all interfaces. It overrides
any interface level passive mode. OSPF shall not form adjacencies over a passive interface.
Default
Format passive-interface default
Mode
no passive-interface default(OSPFv3)
Use this command to disable the global passive mode by default for all interfaces. Any
interface previously configured to be passive reverts to non-passive mode.
Format no passive-interface default
Mode
passive-interface (OSPFv3)
Use this command to set the interface or tunnel as passive. It overrides the global passive
mode that is effective on the interface or tunnel.
Default
Format passive-interface {<slot/port> | tunnel <tunnel-id>}
Mode
4
Router OSPFv3 Config
Router OSPFv3 Config
disabled
Router OSPFv3 Config
Router OSPFv3 Config
disabled
Router OSPFv3 Config
