8
iCN 600 series | User Manual
5. Position in a Vehicle
Before you begin, check if your vehicle is fitted with a heat reflecting or heated windshield. If so, you will need to
purchase an external antenna for your iCN to receive GPS signals.
There are a number of ways to position an iCN in a vehicle. Follow these instructions carefully.
• Do not install where it could cause interference with vehicle air bags.
• For security and to avoid overheating, do not leave your iCN in an unattended
vehicle, especially in strong sunlight or extremely cold temperatires.
• Do not use or handle the iCN when it is hot — leave it to cool out of direct sunlight. If your iCN is
too hot, you will be prompted to turn down the brightness (press and hold the Zoom button). If the
iCN continues to get hotter the screen will go blank, however voice instructions will continue.
Option One: Suction Mount
1. Slip the locking nut over the ball foot.
2. Snap the mounting clip onto the ball foot and tighten the locking nut onto the thread of the mounting clip.
3. Position the two locating slots on the underside of the iCN into the tabs on the mounting clip.
Push the iCN into the clip.
4. Clean and dry the surfaces, hold the suction cup firmly against the glass and press down the lever.
5. Open the antenna outwards, so it has a clear view of the sky.
6. Plug the power adapter into the socket on the left of the iCN and the other end into the vehicle lighter socket.
