PAGE 26 — MTR40F RAMMER — OPERATION AND PARTS MANUAL — REV. #3 (01/05/12)
1
2
6
7
9
13
8
3
4
10
11
12
15
16
5
18
14
17
NPA-910 J
Oil
öl
I’ huile
SAE30
7~9 cc
NPA-961E
READ OWNER’S SERVICE MANUAL BEFORE OPERATINGOR
SERVICING THIS MACHINE.
ALWAYS KEEPUNAUTHORIZED, INEXPERIENCED,
UNTRAINED PEOPLE AWAY FROM THIS MACHINE.
MAKE SURE ALLSAFETYDEVICESARE OPERATIONAL
BEFORE THIS MACHINE IS STARTED. MAKE SURE ENGINE
IS TURNED OFFAND SPARKPLUG WIRE DISCONNECTED
BEFORE SERVICING THE MACHINE OR COMING IN
CONTACT WITHANYMOVINGPART. IF EQUIPMENTIS
POWERED BYAN ELECTRIC MOTOR DISCONNECT
ELECTRICAL PLUG.
NEVER LEAVE MACHINE UNATTENDED WHEN OPERATING.
ALWAYS STOP ENGINEANDALLOWENGINETO COOL
BEFORE ADDING FUELOROIL.
NPA-329 J
CLEANING ELEMENT:
Remove the element from the pre-cleaner
Clean the element with solvent
Apply SAE30 motor oil with 7~9 cc, and
squeeze out excess oil before re-installing.
NPA-963 J
3800 ~ 4100 RPM
NPA-957 J
NAMEPLATE
GREASE
NPA-120 J
When you stop
the engine, be
sure to close
the fuel cock
NPA-399 J
PRIMARY AIRFILTER
CHECK DAILY
NPA1018
J
SECONDARY AIRFILTER
SERVICE MONTHLY
NPA1016
J
Tostart, switch must be
in the “ ” positionON
NPA293
J
GASOLINE ONLY
NPA1017
J
Before Operation
Check all nuts and bolts for tightness
Keep machine at the upright operating position to check
1. Give each grease fitting five (5) shots of grease with
a hand grease gun.
2. Check the engine oil level and if the level is low,
it should be refilled from the filler hole.
OPERATION
To START engine:
Open fuel filter valve and close choke lever on carburetor.
Place starter switch to “ON” and pull start rope.
When engine starts, open the choke lever and warm up the
engine for 4-5 minutes before operation.
Then move throttle lever from “OFF” to “ON” to operate.
To STOP engine:
Move the throttle lever quickly from “ON” to “OFF” position.
Then move starter lever quickly to “OFF” and close the fuel filter valve.
NPA-1100J
Gasoline Only
Bitte nurBenzine einfüllen
Essence Uniquement
Usare solo Benzina
Solo para Gasolina
NPA-896J
LAY DOWN TOWARDTHIS
DIRECTION ONLY
Read operator’s manual carefully before use.
Lire le manuel attentivement avant utilisation.
Bitte lesen Sie vor lnbetriebnahme der Maschine die
bedienungsanleitung sorgältig durch.
Prima delÍ uso leggere attentamente il manuale.
Lee com atenÇão manual de instruÇõ antes de
usar.
Leer detenidamente el manual de instrucciones
antes de usar la maquina.
CAUTION
ATTENZIONE
ATENÇAÕ
PRECAUCION
NPA-769 J
CLEAN THE ELEMENT WITH KEROSENE WHEN DIRTY.AFTER THE
CLEANING, LUBRICATE IT MIXED OIL(KEROSENE 2~4: ENGINE OIL
1), SQUEEZE OUT THE OIL, AND REPLACE IT.AND CLEAN IT MORE
OFTEN WHEN OPERATING IN DUSTY CONDITIONS.
NPA-831J
NAMEPLATE AND DECALS
