Installation
^
Remove the cable clip from the back
of the appliance.
^
Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
^
Carefully push the appliance into
position with the back against the
wall.
Aligning the appliance
^ To align the appliance, adjust the
front feet using the spanner supplied.
Stainless steel appliances
^
If necessary, also align the two rear
adjusting devices a using a socket
wrench b.
Turn the adjusting device clockwise
to raise the appliance up at the back.
Levelling the appliance door
^
Ensure that you unscrew adjusting
foot c from the hinge plate until it sits
on the floor. Then unscrew the foot by
a further 90°.
Installation
45
