NAMES AND
FUNCTIONS
4
BASIC
CONNECTIONS
BASIC
OPERATION
ADVANCED
CONNECTIONS
SETUP
ADVANCED
OPERATION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTIONS
ENGLISH
REMOTE CONTROL
Operate the remote controller within a distance of
approx. 16.4 ft from the infrared receptor window
on the front of the unit.
Approx. 5m (16.4 ft)
Remote controller
Caution
• Do not allow direct sunlight, an inverter
fl uorescent light or other strong source of light to
shine onto the playerʼs infrared receptor window.
Otherwise, the operation of the remote controller
may be disabled.
• Bear in mind that operating the remote controller
may cause other devices operated by infrared
rays to be operated by mistake.
• The remote controller cannot be operated if the
space between the controller and the playerʼs
infrared receptor window is obstructed.
• Do not place any objects on top of the remote
controller.
Doing so may cause one or more buttons to be
held down which will cause the batteries to run
down.
BEFORE USE
NAMES AND FUNCTION
FRONT PANEL
SR6004
qw e tyu i o !0 !1 !2 !3 !4!5 !6
!7!8@0@1@2
r
!9
SR5004
qw e tyu i o !0 !1 !2 !3 !4!5 !6
!7!8@1@2
r
!9
q POWER switch and STANDBY
indicator
When this switch is pressed once, the unit turns ON
and the display illuminates. When pressed again,
the unit turns OFF and the STANDBY indicator will
be illuminated.
w INPUT SELECTOR knob
This knob is used to select the input sources.
(See page 16)
e SURR. MODE button
Press this button to select the surround mode.
r DYNAMIC VOL. indicator
This indicator illuminates while the Audyssey
Dynamic Volume
TM
is in use.
t DYNAMIC EQ. indicator
This indicator illuminates while the Audyssey
Dynamic EQ
TM
is in use.
y AUTO button
Press this button to select the AUTO mode from the
surround modes. When this mode is selected, the
unit determines the surround mode corresponding
to a digital input signal automatically.
u PURE DIRECT button
Press this button to select the pure direct mode or
source direct mode.
i DISPLAY button
Press this button to change the FL display mode.
