Section 3 Dispenser Operation
3-3
With Top-Mounted Ice Machines
Installation Procedures
WARNING
Do not attempt to move a dispenser without first
removing the ice machine. The combination can be
unstable and could tip, causing serious injury.
1. Review the installation Check List on pages 3-1
and 3-2. Make sure all utility and space
requirements are present at the installation site.
2. Remove the carton top from the dispenser.
3. Remove the legs and other accessories from inside
the dispenser bin.
4. Remove the carton from the sides of the dispenser.
5. Remove the dispenser from the shipping pallet.
6. Flatten the shipping carton.
7. Lay the dispenser on it back on the carton.
(Save carton for possible future use.)
8. Thread the legs into the bottom of the dispenser.
9. Set the dispenser upright.
10. Place the dispenser in the desired location.
11.Make sure the dispenser bin top is level. A level
bin is important for proper operation of the ice
machine.
12. Place the ice machine on top of the dispenser at
this time.
13.The back of the ice machine is secured to the back
of the dispenser with the supplied mounting clip
(metal plate). The clip is pre-punched with to
holes for screws. One screw is attached through
the clip and the ice machine. The other screw is
attached through the clop and the dispenser.
14.Connect the drain of the dispenser to the floor
drain. Vent the drain at the back of the dispenser
to reduce buildup of algae and improve drainage.
15.Follow local plumbing codes for drain installation.
16.If the dispenser has a water valve, connect your
water line to the water connection at the back of
the dispenser.
17.Test all drain and water lines for leaks.
18.Plug the dispenser into the proper electrical outlet.
