LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
ACCESSORIES (Fig. 3)
1. With SNOOT open accessories can be installed or removed.
2. INSTALLING ACCESSORIES: Push accessory(s) into SNOOT
snapping them into ACCESSORY SPRINGS.
NOTE: There must always be (1) accessory or clear glass
installed in the SNOOT for safety reasons. This FIXTURE
takes (2) accessories maximum with or without C R O S S B L A D E.
3. REMOVING ACCESSORIES: Push ACCESSORIES out of
ACCESSORIES SPRING. Push one ACCESSORY SPRING
against SNOOT if accessory is difficult to remove.
CROSSBLADE may be removed. Pull CROSSBLADE out of
SNOOT.
INSTRUCTION SHEET NO.
IS:26556MC Y
0798 Page 2 of 2
CLOSE SNOOT OVER LAMP (Fig. 3)
1. Rotate SNOOT until SLOT mates with ACCESS KNOB.
2. Tighten ACCESS KNOB to secure SNOOT.
FIXTURE OPERATION (Fig. 4)
Turn LAMP on or off by activating the switch. (Fig. 2)
SETTING HORIZONTAL ROTATION
1. Rotate fixture to desired horizontal position. Fixture provides
360° rotation.
CAUTION: There is a STOP that prevents the FIXTURE from
being adjusted more than 360°. Do not force F I X T U R Ea g a i n s t
the STOP. Rotate the FIXTURE in the opposite direction to
obtain the proper aiming location.
SETTING VERTICAL ROTATION
1. Loosen SIDE KNOB.
2. Turn FIXTURE to desired vertical position. The FIXTURE adjust
90° in the vertical direction.
Do not force past the adjustability limits.
3. Tighten SIDE KNOB.
SETTING LAMP ROTATION
1. Loosen LAMP ADJUSTMENT KNOB a few turns.
2. Drive LAMP ADJUSTMENT KNOB in 180° slot.
3. Tighten LAMP ADJUSTMENT KNOB after LAMP is in desired
position.
SETTING ACCESSORY ROTATION
1. Loosen ACCESSORY KNOB a few turns.
2. Rotate SNOOT to desired position. SNOOT rotates 360°.
3. Tighten ACCESSORY KNOB.
ACCESS KNOB
ACCESSORIES
ACCESSORY SPRING
CROSSBLADE
SLOT
SNOOT
Fig. 3
Fig. 4
HORIZONTAL ROTATION
SNOOT
VERTICAL ROTATION
SIDE KNOB
ACCESSORIES ROTATION
ACCESSORIES KNOB
LAMP ADJUSTMENT
KNOB
180° SLOT
LAMP ROTATION
