Lennox Hearth 999995 Manual

A SERVICE OF

next previous

9

STEP 4 Replace and tighten the 1/2” pipe plug and clean away any excess oil.

See Figure C.

STEP 5 Remove 1/2” Pipe Plug (Located at top of side gearbox, See Figure D)

and the 1/8" check plug (Located in side of the side gearbox).

STEP 6 Fill side gearbox using gear oil until the oil begins to overflow from the

checkplug hole. See Figure E.

STEP 7 Replace and tighten the 1/2” vent plug and the 1/8" check plug. Clean

away any excess oil. See Figure F.

STEP 8 Grease the grease fitting on the "out-board hub," the two (2) grease fittings on

the PTO universal joints, the two (2) grease fittings on the PTO safety shield

and the inner surface portion of the PTO shaft. See Figures G,H and I.

CAUTION:

DO NOT over fill gearbox. This could cause damage to oil seals and can

cause permanent damage to the gearbox. This issue will not be covered

under warranty.

Figure A Figure B

Figure C