WARNING
Risk of injury or damage due to hot steam.
Hot steam can cause scalding/burns and damage to
surfaces.
u
Do not use steam cleaners.
NOTICE
Incorrect cleaning damages the appliance.
u
Do not use concentrated cleaning agents.
u
Do not use steel wool or sponges that scour or scratch.
u
Do not use caustic or abrasive cleaning materials or
those containing sand, chloride, chemicals or acids.
u
Do not use chemical solvents.
u
Do not damage or remove the rating plate on the inside
of the appliance. It is vital for the customer service
department.
u
Do not pull off, kink or damage any cables or other
components.
u
Do not let cleaning water get into the drain gutter, the
ventilation grille and electrical parts.
u
Use soft cleaning cloths and a multi-purpose cleaning
agent with a neutral pH value.
u
Only use food-compatible cleaning and care agents
inside the appliance.
u
Empty the appliance.
u
Disconnect the power plug.
u
Clean the plastic surfaces, outside and inside, by
hand using lukewarm water and a little dish washing
liquid.
Stainless steel which is exposed to chlorine gas or damp-
ness may become discolored. This is normal. If your
appliance is exposed to chlorine gas or dampness, clean
and polish it more frequently. If there are any signs of rust
or discoloration, clean and polish the appliance as soon
as possible.*
Do not apply stainless steel cleaning agents to glass or
plastic surfaces so as not to scratch them. Initially darker
areas and quite an intensive color of the stainless steel
surfaces are normal.*
u
If dirty clean external stainless steel surfaces with a
commercially available stainless steel cleaning agent.
Then apply the supplied stainless steel cleaning agent
evenly in the direction of the grain.*
Do not clean the glass door with abrasive cleaning
agents or rough cloths. Otherwise the surface and the
frame may become dull or be scratched.
u
Clean the glass door with a standard glass cleaner and
a soft cloth.
u
Clean fittings by hand using lukewarm water and a
little dish washing liquid.
After cleaning:
u
Wipe the appliance and accessories dry.
u
Connect the appliance and switch it on again.
u
Switch on SuperFrost (see 5.7.4) .
When the temperature is sufficiently cold:
u
put the food back in the appliance.
6.5 Cleaning the IceMaker
The IceMaker drawer must be emptied and pushed in.
u
Activate setting mode: press and hold the SuperFrost
button
Fig. 2 (2)
for approximately 5 s.
w
S is shown on the display.
w
The Menu symbol
Fig. 2 (22)
lights up.
u
Using the Freezer compartment Up button
Fig. 2 (5)
/
Freezer compartment Down button
Fig. 2 (4)
, select I.
u
To confirm: press the SuperFrost button
Fig. 2 (2)
.
u
Using the Freezer compartment Up button
Fig. 2 (5)
/ Freezer compartment Down button
Fig. 2 (4)
, select Ic.
u
To confirm: press the SuperFrost button
Fig. 2 (2)
.
w
The IceMaker moves into cleaning position and shuts
off.
u
Deactivate setting mode: press the Freezer compart-
ment On/Off button
Fig. 2 (3)
.
-or-
u
Wait 2 min.
w
The temperature is again displayed on the temperature
display.
u
Take out the drawer.
u
Clean the ice compartment and drawer with warm
water. If necessary, use a mild dishwashing liquid.
Then rinse.
u
Slide the drawer back in.
If dishwashing liquid was used:
u
Throw out the first three batches of ice cubes to get rid
of any dishwashing liquid residues.
Either leave the IceMaker switched off in this position or
switch the IceMaker back on (see 5.7.9) .
6.6 Customer service
First check whether you can remedy the fault yourself
(see Troubleshooting). If this is not the case, please
contact a qualified service provider.
WARNING
Risk of injury from repairs by non-professionals.
u
Repairs and work on the appliance and the power
supply cable not described in the Manual (see Mainte-
nance) should only be carried out by a qualified service
provider.
u
Read the appliance
designation
Fig. 8 (1)
,
service no.
Fig. 8 (2)
and serial no.
Fig. 8 (3)
from the
rating plate. The
rating plate is
located inside the
appliance on the left-
hand side.
Fig. 8
Maintenance
14 * Depending on model and options
