5: Commands and Levels
192.168.1.1/24 (CIDR)
"192.168.1.1 255.255.255.0" (explicit mask)
Enter link configuration level
Sets the Maximum Transmission Unit (MTU) size.
Clears the default gateway.
Clears the DHCP client ID.
Clears the name of the primary DNS server.
Clears the name of the secondary DNS server.
Sets the IP address of the primary DNS server.
secondary dns <IP address>
Sets the IP address of the secondary DNS server.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI
session.
Stores the current configuration in permanent memory.
ip (config-ip) level commands
Restores the default IP time to live.
default multicast time to live
Restores the default IP multicast time to live, which is one hop.
Exits to the configuration level.
Sets the IP time to live, known by SNMP as "ipDefaultTTL".
<hops> = number of hops that a typical IP packet is allowed to
multicast time to live <hops>
Sets the IP multicast time to live.
<hops> = number of hops that a multicast IP packet is allowed to
Displays the current configuration.
Displays the last 20 commands entered during the current CLI
session.
Stores the current configuration in permanent memory.
key 1 (config-profile-security-wep-key:test1:1) level commands
Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
Exits to the next higher level.
Each byte is represented by two adjacent hex digits.
Bytes may run together or be separated by optional punctuation:
123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc
Note that quotes must enclose the value if it contains spaces.
Sets key.
Each byte is represented by a single character.
PremierWave EN Command Reference 180
