1) Connect the antenna or cable TV wire from the wall outlet, in to the RF Input of the two-way splitter.
2) Connect an RF cable from the one of the RF Outputs on the splitter, in to the RF Input on the
back of the VCR.
3) Connect an RF cable from the other the RF Output on the splitter, in to the RF Input on the
back of the TV.
4) Connect the yellow video cable out from the VCR’s Video Output, in to the TV’s Video Input
jack, OR connect an S-Video cable from the VCR’s S-Video output, to the TV’s S-Video input.
5) Connect the white audio cable out from the VCR’s Left Audio Output, in to the TV’s Left Audio
Input Jack.
6) Connect the red audio cable out from the VCR’s Right Audio Output, in to the TV’s Right
Audio Input jack.
• If your VCR is a mono sound unit, it will have only one Audio Out jack. Connect it to the TV’s
Left Audio Input.
• Please consult your VCR’s owner’s manual for more information on its operation.
Connections
12
VIDEO
AUDIO
DIGITAL
INTERFACE
R
L MONO
REAR
IN
S-VIDEO
OVER
VIDEO
AUDIO
DIGITAL
INTERFACE
R
L MONO
REAR
IN
S-VIDEO
OVER
VCR
IN
WALL
CABLE or ANTENNA
OUT
OR
OR
TWO-WAY
SPLITTER
Diagram #1
Important Note About Diagrams:
The connection diagrams are intended to show some basic general connections. Some
cable companies may require special connections to properly use your television. If you
follow these diagrams and the television does not work properly, contact your local
cable operator for more connection information.
Hotel IB 6/28/2001 10:13 AM Page 12
