A SERVICE OF

logo

Energy Display Owner’s Manual
Page 9 of 13 2448A2 - Rev: 1/21/2014 8:45 AM
Temperature Calibration Mode
NOTE: Green text indicates flashing text on the Energy Display screen.
The Energy Display temperature comes pre-calibrated. Only perform these steps if re-calibration is
necessary. Please allow 20 minutes for temperature to adjust when moving to an area with a significant
temperature change.
Button
Action
Hold/Up
Tap to set local temperature (based on a thermostat or other device)
Note: Place Energy Display close to your temperature reference device (e.g.,
thermostat or thermometer) for approximately 20 minutes to ensure it is settled to a
stable temperature.
1-2-3/Down
Refresh/OK
Tap to accept current local temperature
Mode/Setup
Tap to exit Setup Mode