25
5.1 Preparing for menu operations
If Simple Stack without an RS-232 connection is used, press the related source
button on the remote control or press the projector's
INPUT
button to select the
port which has the connected cable. For setting up MONITOR OUT, refer to
SETUP menu
in
Operating Guide
.
This completes set up.
If Intelligent Stack with the RS-232 connection is used, all settings or modications
related to Intelligent Stack menu operations must be completed using the Main
projector. The Main projector functions according to the Intelligent Stack settings
5.2 Checking Main projector's operating status
For Intelligent Stack, all settings or modications related to menu operations must
be completed using the Main projector. Before operating the menu for Intelligent
Stack, check if the Main projector is functioning.
1.
Press the
MENU
button on the remote control.
2.
If the MENU dialog as shown on the right appears on
the screen, the two projectors are operating in DUAL
mode and the Main projector is operating.
Go to
5.4 Setting the menu
. (
27
)
If the dialog does not appear, LAMP MODE is set to ALTERNATE and either
the Main or Sub projector is operating. Go to next.
3.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION
> STACK
STACK menu will appear on screen.
(
Operating Guide
→
OPTION menu
)
4.
Check the STACK MODE setting in the STACK menu.
- If MAIN is displayed, the Main projector is operating. Go to
5.4 Setting the
menu
.
(
27
)
- If SUB is displayed, the Main projector is turned off and the Sub projector is
operating. Go to
5.3 Starting up Main projector
. (
26
)
5. Setting input ports using menu
