59
7
REFERENCES
7
Connection to the
AP-12 has failed
after restoring.
No IP address is
assigned from the
DHCP server.
Wireless LAN ter-
minal(s) unable to
obtain an IP ad-
dress from the
DHCP server via
the AP-12.
“Automatic” is im-
possible to set.
[AP-12 Manager]
or [Easy Setting
Wizard] cannot
find the AP-12.
Wireless commu-
nication is impos-
sible.
Communication
with wireless LAN
card via access
point mode has
failed.
The network part of the AP-
12’s IP address is different
from the PC’s because of the
restoring.
• Ethernet cable is not connect-
ed to wired LAN within 30
sec. from turning the AP-12
power ON.
• “Manual settings” is select-
ed.
• No DHCP server is available
in the connected wired LAN.
• No DHCP server is available
in the connected wired LAN.
• Fixed IP address is set to
wireless LAN card.
• “Bridge Mode B” is selected
as the Functional mode.
“Bridge Mode B” is selected
as the functional mode.
• The network part of the AP-
12’s IP address is different
from the PC’s.
• In case of using Windows
XP, “Enabled, Firewalled” is
indicated on the [Local Area
Connection] icon.
• The personal firewall soft-
ware is activated.
ESS ID or WEP security set-
ting is different between the
units.
“Adhoc” mode is selected with
the wireless LAN cable.
Reset the AP-12’s IP address
using [Easy Setting Wizard]
or the [AP-12 Manager].
• Turn the AP-12 power OFF.
After waiting a few seconds,
turn power ON again, then
check the IP address.
• Select “Automatic” and con-
nection method.
• Confirm the DHCP server
availability.
• Confirm the DHCP server
availability.
• Set the wireless LAN card to
obtain an IP address from
the DHCP server.
• Select “Access Point Mode”,
“Bridge Mode A” or “C”.
Select “Access Point Mode”,
“Bridge Mode A” or “C”.
• Set the AP-12’s IP address
using [AP-12 Manager].
• Right-click [Local Area
Connection] icon and click
[Properties]. Then, select
[Advanced] tab in the menu.
Clear the [Internet Connection
Firewall] check box.
• Set the software to enable
access to the AP-12.
*See the software’s instruction
manual or for details.
Set the same ESS ID or WEP
security setting.
Select “Infrastructure” mode.
pgs. 17,
61
p. 10
p. 36
—
—
p. 36
p. 34
p. 34
p. 62
p. 52
—
pgs. 33,
38
—
PROGRAM POSSIBLE CAUSE SOLUTION REF.
AP-12_USA 02.7.26 9:32 AM Page 59 (1,1)
