27
Presentation
Only fill antifreeze and water ready mixed in a 50/50
ratio.
Check the level when the engine has been driven for a
few minutes after filling. There could have been air in the
system which has now been released.
Antifreeze
Only use a glycol based antifreeze that is approved by
the applicable norms BS 6580:1992 or ASTMD 3306-89
or AS 2108-1977 (indicated on the packaging).
The antifreeze agent must be intended for use with light
alloy engines.
Your Husqvarna supplier can provide the correct type of
antifreeze agent.
Use antifreeze agent all year round and even in
climates that do not have a risk of frost. The antifreeze
agent contains additives that protect the engine
cooling system against corrosion.
Cutting unit
PT 26D can be equipped with cutting unit, Combi 132
with a 132 cm cutting width or Combi 155 with a
155 cm cutting width.
The cutting unit is driven by a v-belt, a power take-off
shaft and a propeller shaft from the engine. It is
engaged by an electro magnetic clutch, which is
located in front of the engine’s flywheel.
The Combi unit functions as a BioClip unit when a
BioClip plug is fitted under the unit cover, but can be
set to rear ejection by removing the BioClip plug.
The unit’s BioClip function finely chops the grass
several times before returning it to the lawn as
fertiliser. The rear ejector ejects the clippings behind
the unit without finely chopping them.
Cutting unit Combi 155 can be mounted 8 cm (3 1/8")
IMPORTANT INFORMATION:
IMPORTANT INFORMATION:
Never fill a hot engine with cold coolant. Risk of
extensive engine damage.
If you use the incorrect type or mix different types of
antifreeze agents, a chemical reaction may occur,
which causes overheating and severe engine damage.
These are not covered by the warranty.
Mixing table
Glycol Water Freezing point
60 % 40 % - 47 ¡C
50 % 50 % - 37 ¡C
40 % 60 % - 25 ¡C
