A SERVICE OF

logo

Open as PDF
next previous
English – 43
8009-289
6017-108
Combi 112
8009-288
6017-162
BioClip 103
MAINTENANCE
Removal of BioClip plug (Combi)
To change a Combi unit from BioClip function to
cutting unit with rear ejection, remove the BioClip
plug located under the unit with three screws.
1. Put the unit in the service position, see ”Placing
in the service position”.
2. Remove the three screws holding the BioClip
plug, and remove the plug.
3. Tip: Fit three full-thread screws M8x15 mm in
the screw holes to protect the threads.
4. Replace the unit in normal position.
Fit the BioClip plug in the reverse order.
Cutting unit models
The following versions of cutting units can be used
on this type of machine:
Cutting unit with rear ejection 97 and 120
Removal of BioClip plug