OWNER'S MANUAL
HD1610 ASSEMBLY
PAGE 33
GENERAL MAINTENANCE INFORMATION
(CONTINUED)
Belt and Cable Tension:
* Referring to the Owners Manual, when belts or cables are used check all
bolts attachments to be sure they are properly attached.
* Check slack in cables and re-adjust cable tension if needed.
Seat Sleeves, Guide Rods:
* Wipe down adjusting tubes with a dust free rag before applying lubricant.
* Lubricate seat sleeves and Guide Rods with a Silicon or Teflon based
lubricant spray.
Linear Bearings:
* Referring to the Owners Manual carefully disassemble the bearing from
its housing and place a finger full of light grease (lithium, super lube, etc.)
into the inside of the bearing. Using your finger, press the grease into the
ball-bearings and their tracks. repeat until the ball-bearing tracks are full
of grease. Insert the shaft back into the bearing and wipe off excess
grease.
PLEASE KEEP THIS FOR YOUR RECORDS
