Installation
Typical LCD Projector and Screen Installation
Use the diagram below as reference to determine the screen size and projection distnace.
Screen
-" S
_) Side view
To_D view ) \_
/
_h
)
)
Screen size (inches) b (inches)
a (inches)
Minimum Maximum
55 73
85 114
114 151
144 191
176 231
220 282
291 386
4O 1
6O 2
8O 2
100 3
120 3
150 4
200 6
Using the adjusters ]
a. Distance from the LCD projector to the screen
b.Distance from the lens center to the bottom of
the screen (a,b : +/-10%).
(Caution)
The LCD projector should normally be used
level (the legs can point upward).
Positioning the projector sideways, or with the
lens pointing upward or downward can cause the
internal temperature to rise, which could result in
a malfunction.
The projection distances shown in the diagram to
the left are for full size (800 x 600 dots).
Use the adjusters on the bottom to adjust the projection angle.
f , Side view
( Front view ) __ \
J
\\
Adjuster Variable within the range of approximately 0° - 9°
1. Lift up the projector and release the adjuster lock.
2. After adjusting the projection angle, firmly lock the adjusters.
3. Rotate the adjusters for fine adjustment.
IAkCautionl • Do not release the locks unless the projector is being held; otherwise, the projector could
overturn or the fingers could get caught and cause personal injury.
• Do not force the adjusters to rotate. This could damage the adjusters or cause the lock to fail.
• Lock the adjusters firmly. If the lock is difficult to operate, change the angle slightly and try again.
12
