Read Usage Notes ( to ) carefully to ensure maximum safety before proceeding to
these steps:
(1) Choose an appropriate site and install the product on a level table where the stand is secure.
Install the monitor to have ready access to a power socket available.
(2) Make sure that the monitor’s power switch is off.
The monitor is shipped with the power switch off.
(3) Make sure that the video equipment’s power switch is off.
(4) Interconnect the signal input terminal on the monitor rear panel and the video equipment’s
signal output terminal to each other using an optional cable.
(5) Insert one end of the power cable included into the rear-panel power cable connector and
the other end into a power socket.
If a power adapter is used, ground the grounding wire to avoid electrical shocks and radio
interference. (Complete grounding before connecting the power plug to a power supply. Before
disconnecting the grounding wire, be sure to disconnect the power plug from the power supply
first.)
(6) Turn on the monitor, then the video equipment’s to make sure that a display image appears
on the monitor screen.
For instructions on turning on the monitor and adjusting its display images, see “Operating
Instructions” ( to ).
If video equipment with an S video input terminal is used, cabling by the S video cable is
recommended to provide finer video quality. (If an S video input terminal and a video
input terminal connect to the monitor at the same time, S video input would govern.)
13 21
3 6
