A SERVICE OF

logo

Open as PDF
next previous
Hardware options installation 61
To install the component:
1. Power down the server (on page 20).
2. Do one of the following:
o Unlock and remove the bezel ("Open or remove the tower bezel" on page 20).
o Extend the server from the rack (on page 21).
3. Remove the access panel (on page 21).
4. Remove the applicable media bay blanks ("Remove the media bay blank" on page 23).
IMPORTANT: For correct cabling, install the full-height tape drive in the top two slots.
5. Identify the guide screws ("Identifying guide screws" on page 57).
6. Install the guide screws.
7. Install the tape drive.
8. Install a SAS controller ("Installing expansion boards" on page 63).
9. Connect the power cable to the rear of the drive.