A SERVICE OF

logo

Open as PDF
next previous
2. Use the Mylar tab to slide the assembly to the right (3) to disconnect it, and remove the
assembly (4).
3. Remove the mounting bracket.
On a hard drive:
a. Remove the 4 Phillips PM3.0×3.0 screws (1) that secure the hard drive bracket to the hard
drive.
b. Using the Mylar tab, lift the bracket (2) away from the hard drive.
– or –
On a solid state drive:
a. Remove the 4 Phillips PM2.0×3.0 screws (1) that secure the solid-state drive bracket to the
solid state drive.
b. Lift the solid-state drive module (2) to remove it.
Component replacement procedures 49