2-7
Installing the Switch
Installation Procedures
Installing the Switch
1
If you are using the yl module in either of the 3500yl or 6200yl switches with an X2 transceiver
installed, the operating ambient temperature should not exceed 40°C (104°F).
b. Push firmly until the gasket seats against the bulkhead.
Figure 2-3. Securing a transceiver bail.
Note When switch power is on, the Link and Activity LEDs will come on for
approximately two seconds and then go off. This is confirmation the trans-
ceiver is completely seated.
c. If your transceiver has a bail, move the bail up, if not your transceiver is
now completely installed. Refer to the HP ProCurve Switch yl Module Instal-
lation Guide for more details.
To remove the transceiver:
If your transceiver has a bail, lower the bail until it is approximately horizontal,
and then using the bail, pull the transceiver from the slot. If your transceiver
does not have a bail, pull the transceiver straight out.
4. Install or Remove mini-GBICs (Optional)
You can install or remove a mini-GBIC from a mini-GBIC slot without having
to power off the switch. Use only HP ProCurve mini-GBICs.
Notes ■ The mini-GBIC slots are shared with the four 10/100/1000Base-T RJ-45
ports. If a mini-GBIC is installed in a slot, the associated RJ-45 port is
disabled and cannot be used.
■ The mini-GBIC ports operate only at full duplex. Half duplex operation is
not supported.
■ Ensure the network cable is NOT connected when you install or remove
a mini-GBIC.
Bail
