Heath Zenith 6180 Series Manual

A SERVICE OF

next previous

-2-

595-5506-12

12345

678

Jumpers

Chime Volume

SawtoothHanger

Figure 4

5. Mount push button.Useeitherscrewsordouble

sidedtapetomountpushbutton.

• ScrewMounting:Tomountwithscrews,remove

backofcasebypushingintabonbottomwithasmall

screwdriver(seeFigure1).Note: Remove material in

screwholes(ifneeded)beforemountingwithscrews.

Attachbackofcasetodoorjamborwall(seeFigure

3).Snapfrontofpushbuttonon.

• Tape Mounting:Whenattachingpushbuttonusing

double sided tape, make sure the surface of the door

jamborwallisclean.

6. Mount chime.

Determinemountinglocation.

 Therearedifferentwaystomountthechimedepending

uponthemodelofchimepurchased.Determinewhich

modelyoupurchasedbelow.Mountthechimeaccording

totheinstructionsforyourchime.

ChimewithAttachedDecorativeCover:

1. Drill1/4"diameterpilotholeforwallanchor(provided)andinsertanchor.

2. Screw#8screw(provided)intoanchor.Leave1/16"gapbetweenscrewhead

andwall.

3. Placehangeroverscrewtomountchime(seeFigure4).

Figure 3

SawtoothHanger

Screw