4-10
4.3 RP Board RP-26
The RP Board RP-26, which providesvideo plotter functions, consists of a circuit
board and a card drive both of which are accommodated in the display unit of the
FR-2105 series radar.
Table top/console type
Necessary Parts: RP-26-T-2E (008-485-520)
emaNepyTytQ.onedoC
draobPR8920P411046-784-800
.yssaesacdraC–1–
BwercsdaehnaPW0072C8x4M4544-188-000
BwercsdaehnaPW0072C8x3M2404-188-000
AwercsdaehnaPW0072C5x6.2M2379-008-000
rehsawkcoldehteeT
)hteetedistuO(
W1915C4M1605-468-000
.yssaelbaC25-A-A-D001-6FIH1355-731-000
1. Lift the monitor and fix it with the stay. Refer to Chapter 1 for instructions.
2. Remove the right arm cover from the control head.
3. Fasten the card case to the right arm cover as follows:
a) Fasten the ground wire with an M4x10 screw and washer (supplied) as shown
below.
b) Fasten the arm cover to the card case with three M4x8 screws (supplied).
✩❯P✄❋❘❨❍❯✄☛❯▲❏❑❲☞
✸❉◗❑❍❉●✄❱❋❯❍❩✂
✵✗❀✔✓★✂
✸❉◗❑❍❉●✄❱❋❯❍❩✂
✵✗❀✛★✖✄❙❋❱✑★✂
✿❉❱❑❍❯✂
✵✗★✂
Card case
✯❯❘❳◗●✄❩▲❯❍
Figure 4-9 Fastening the card case to the right arm cover
