Assembly
12
• Fit the lens tabs on the back of a lens assembly into the
headlight slots in the grille.
• Press firmly to snap the lens assembly into the grille.
• Repeat this procedure to snap the other lens assembly
into the grille.
Grille
Tabs
Slots
9
• Insert a hood latch into one of the holes in the vehicle
body, near the hood area.
• Twist the base of the hood latch
1
/
4
turn to secure it in
the vehicle body.
• Repeat this procedure on the other side of the hood
area to attach the other hood latch to the vehicle body.
Hood Latch
Hole
10
Hood
Latch
Hole
• With the flat sides of the windshield brackets facing the
dash, fit the screw pegs on the windshield brackets into
the holes in the top surface of the dash.
• Insert two #8 x 1" screws into each windshield bracket.
• Tighten the screws with a Phillips screwdriver.
• Do not over-tighten.
Windshield
Brackets
#8 x 1" Screws
#8 x 1" Screws
Hood
Tabs
• Position the hood over the front of the vehicle body
as shown.
• Insert the tabs on the hood into the slots in the
vehicle body.
• Close the hood.
Slot
Slot
11
12
