10
Switches and Controls:
Main Power Switch:
Located on top panel on the Take-up side of the platter. Marked as POWER
The power switch is only used to turn the platter on and off.
Fuse Location and Ratings:
The fuse is located next to the power switch, and marked for rating and type.
Plug Location:
The platter uses a standard IEC type input plug assembly, and uses a standard
computer-type AC cord. It is located at the bottom of the mast on the same side.
The platters are pre-wired from the factory for either 110 or 220V operation, and noted
on the Serial Number label.
Motor Engage Control:
Each of the three motors has it s own latch to engage or disengage the motor
drive puck against the inside lip of the deck. This latch applies pressure against
the motor, so the drive puck positively turns the deck. The handle for the latch
has two positions:
ENGAGE (towards mast) pushes drive motor against platter rim
DISENGAGE (away from mast) drive motor is pulled clear of platter
If the motor is not in the correct location, the platter deck will not turn. Always be
sure motors are engaged before starting any show.
