Fuse blown, or the
circuit breaker acted
Re
lace fuse or reset circuit breaker. Remove an
other
appliances sharing the same circuit with the dishwasher
Sound from soft food shreddin
action and deter
ent
cup opening.
Utensils are not secure
in the baskets or something
small has dropped into
the basket
To ensure everything is secured in the dishwasher.
Motor hums Dishwasher has not been used re
ularl
. If
ou do not
use it often, remember to set it to fill and
um
out
every week, which will help keep the seal moist.
Im
ro
er deter
ent Use onl
the s
ecial dishwasher deter
ent to avoid suds.
If this occur, o
en the dishwasher and let suds eva
orate.
Add 1
allon of cold water to the tub. Close and latch the
dishwasher, then drain out the water by slowly turning
the dial until a drain period is reached. Repeat if
necessary.
Spilled rinse agent Always wipe up rinse agent
spills immediately.
Deter
ent with
colorant was used
Make sure that the deter
ent is the one without colorant.
Rinse agent dispenser
is empty
Make sure that the rinse agent dispense is filled.
Clogged air gap Clean the air
a
.
Improper rack loading Make sure that the action of the deter
ent dis
enser
and spray arms are not blocked by large dishware.
Extremel
hard water
Low inlet
temperature
Overloading the
dishwasher
Improper loading
Old or damp powder
detergent
Empty rinse agent
dispenser
Incorrect dosa
e of
detergent
To remove s
ots from
lassware:
Take out all metal utensils out of the dishwasher.
Do not add detergent.
Choose the longest cycle.
Start the dishwasher and allow it to run for about
18 to 22 minutes, then it will be in the main wash.
Open the door to pour 2 cups of white vinegar
into the bottom of the dishwasher.
Close the door and let the dishwasher complete
the cycle. If the vinegar does not work: Repeat
as above, exce
t use 1/4 cu
60 ml
of citric acid
crystals instead of vinegar.
Some audible sounds are
normal
'
Make sure the dishwasher is turned on and the door is
closed securely.
Pressed the Start button.
Make sure the
ower cord is
ro
erl
lu
ed into the
wall socket.
Power supply is turned
off
Start button isn"t pressed
'
Overflow The s
stem is desi
ned to detect an overflow. When it
does, it shuts off the circulation
um
and turns on the
drain pump.
1
