Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
Remove the lower basket and then unscrew and remove the cap from the salt
container.
If
ou are fillin
the container for the first time ,fill 2/3 of its volume with water.
Place the end of the funnel(supplied) into the hole and introduce about 2kg of
salt .It is normal for a small amount of water to come out of the salt container
1
2
4
3
Unscrew the cap from the salt container.
There is a ring on the container with an arrow on it (see Figure to the side), if
necessary, rotate the ring in the anticlockwise direction from the "-" Setting
toward the "+" sign, based on the hardness of the water being used.It is
recommended that adjustments should be made in accordance with the following
schema:
1
2
1.
2.
The salt container must be refilled when the salt warnin
li
ht comes on. Thou
h the salt container is filled
enough, the indicator light may not black out before the salt fully dissolve.
If there are spills of the salt, a soak program could be run to wipe them out.
Contact
our local water board for information on the hardness of
our water su
l
.
The hardness of the water varies from
lace to
lace. If hard water is used in the dishwasher, de
osits will form on the dishes
and utensils.
The a
liances is e
ui
ed with a s
ecial softener that uses a salt s
ecificall
desi
ned to eliminate lime and minerals from the
water.
There are two ways to reduce the hardness: one way is using water softener, the other is using
detergent.
water
If your model have not water softener, you may skip this section.
