Electrolux 134709300 Manual

A SERVICE OF

next previous

19

Reversing Door

 1 Besureyouhaveadequateswingareabeforereversingdoor.

2 You will need a screw driver with a #2 square bit.

 3 Protectatworksurface,suchastopofdryeroroorneardryer,

with a soft cloth or towel.

 4 Besuredryerisunpluggedfrompowersource!

WARNING

ELECTRICALSHOCKHAZARD

Failure to disconnect power source before servicing

couldresultinpersonalinjuryorevendeath.

A)RemovingTrimRing

1 Open door to 90 degree angle.

2 Remove and save trim plug and long,

course-thread, panhead screw.

3 Close door.

 4 Rotatedoortrimapproximately¾”counter-

clockwise and pull ring away from door.

 4 Gentlyplacedoorfacedownonat,covered

work surface.

3 While supporting door with the other hand,

remove 3 short, ﬁne-thread, counter-sunk

screws.

B)RemovingDoorfromFrontPanel

1 Reopen door to 90 degree angle.

2 Remove 2 short, course-thread, panhead

screws.

Preparing to reverse door swing

Removing door and hardware

Screwdrivers with

#2 square &

straight bit

Tools needed: