7
STARTING WARM ENGINE
PB-413T/PB-620
1. Replaces Step 1 in Operator’s Manual:
Throttle Position/Stop Switch Button
Slide Throttle Position/Stop Switch Button (A) back to idle position
(first position away from STOP position.)
2. Follow remaining warm engine starting instructions in Operator’s
Manual.
STOPPING ENGINE
PB-413T/PB-620
Replaces Steps 1 & 2 of “Stopping Engine” in Operator’s
Manual:
1. Trigger - Throttle Position/Stop Switch Button
Release throttle trigger if depressed. Move Throttle Position /Stop
Switch Button (A) forward to IDLE position and allow engine to return
to idle for 30 seconds before shutting off.
2. Throttle Position/Stop Switch Button
Move throttle Position/Stop Switch Button (A) all the way forward to
STOP position.
OPERATING BLOWER
This information applies to “Operating Blower” section of
Operator’s Manual:
Throttle Trigger Operation - Place Throttle Position/Stop Switch Button in
“IDLE” position, and control blower speed with throttle trigger. Release
trigger and allow unit to idle when blower action is not needed.
NOTE
When trigger is released, blower returns to speed set by Throttle
Position/Stop Switch Button.
Throttle Position/Stop Switch Button Operation - Control and set blower
speed by sliding button to desired speed. Slide button to “IDLE” position
when blower action is not needed.
Read and obey all blower operating and safety instructions in Operator’s
Manual.
CRUISE CONTROL KIT INSTALLATION INSTRUCTIONS
A
A
A
