DeWalt D2002M Manual

A SERVICE OF

next previous

16

English

CODE POSSIBLE CAUSE POSSIBLE SOLUTION

4 Defective air tank Air tank must be replaced. Do not repair the leak.

WARNING: Risk of bursting. Do not drill into, weld or

otherwise modify air tank or it will weaken. The air tank can

ruptureorexplode.

5 Leaking seals Contact a D

e

WALT factory service center or a D

e

WALT

authorized service center.

6 Defective safety valve Operate safety valve manually by pulling on ring. If valve

still leaks, it must be replaced.

7

Regulatorisnotadjustedcorrectlyforaccessorybeing

used

It is normal for some pressure drop to occur when an acces-

soryisused,adjusttheregulatorasinstructedinRegulator

under Features if pressure drop is excessive.

NOTE:Adjusttheregulatedpressureunderflowconditions

while accessory is being used.

8 Prolonged excessive use of air Decrease amount of air usage.

9 Compressor is not large enough for accessory Check the accessory air requirement. If it is higher than

the CFM or pressure supplied by your air compressor, a

larger compressor is needed to operate accessory.

10 Hole in air hose Replace air hose.

11 Check valve restricted Contact a D

e

WALT factory service center or a D

e

WALT

authorized service center.

12 Air leaks Tighten fittings.

13 Regulator is damaged Replace.

14 Motor overload protection switch has tripped See Motor Overload under Features.