www.desatech.com
114370-01D 5
PRODUCT
IDENTIFICATION
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specically
approved with this appliance
may result in property damage
or personal injury.
Figure 1 - Product Identication (Ramp
Pan Burner)
Log Set
Assembly
Grate
Chassis
INSTALLATION
WARNING: Before installing
in a solid fuel burning replace,
the chimney ue and rebox
must be cleaned of soot, creo-
sote, ashes and loose paint by a
qualied chimney cleaner. Creo-
sote will ignite if highly heated. A
dirty chimney ue may create and
distribute soot within the house.
Inspect chimney ue for damage.
If damaged, repair ue damper
before operating appliance.
NOTICE: Installation, service and
repair of this appliance must be
performed by a qualied installer,
service agency, company or
gas supplier experienced with
this type of gas appliance. Only
factory authorized components
listed in these instructions may
be used in accordance with the
manufacturer's instructions and
all codes and requirements of
the authority having jurisdiction.
Any modications to or use of
unauthorized components or
accessory items will void the
manufacturer’s warranty and may
result in a hazardous condition.
CHECK GAS TYPE
Use only natural gas. If your gas supply is not
natural gas, DO NOT install this gas log set.
If the replace does not have a gas supply shutoff
valve, one must be installed.
WARNING: This appliance is
equipped for natural gas. Field
conversion is not permitted.
FLUE OPENING SPECIFICATIONS
Note: This vented appliance must be installed
only in a solid-fuel burning replace constructed
of noncombustible material.
The charts in Figure 2, page 6 indicate technical
information regarding the installation of your gas
log set. Please make sure that all of the specica-
tions shown are applicable before installation is
attempted.
The replace must include a ue and venting
system with the minimum openings shown in
Figure 2, page 6.
Ceramic
Burner
