Installing System Components 155
3
Replace the system board.
WARNING: Do not lift the system board by the memory modules latches,
processor heat sink, or any component on the system board.
a
Holding the connector end of the system board up at an angle, lower
the system board into the chassis.
b
Lower the system board securing slots onto the metal hooks in the
chassis.
c
Holding the system board touch points, slide the system board
towards the back of the system, inserting the connectors into the
cutouts in the chassis. See Figure 3-30.
The blue release pin locks into place when the system board is fully
seated.
4
If applicable, replace the SAS backplane. See "Installing the SAS
Backplane" on page 151.
5
Replace heatsinks, processors, and heatsink blanks (if applicable). See
"Installing a Processor" on page 110.
6
If applicable, replace the iDRAC6 Enterprise card. See "Installing an
iDRAC6 Enterprise Card" on page 140.
7
Replace the fan cage. See "Installing a Fan Cage" on page 139.
8
Replace the fan modules. See "Installing a Cooling-Fan Module" on
page 137.
9
Replace all the memory modules. See "Installing Memory Modules" on
page 104.
10
If applicable, replace all the expansion cards. See "Installing an Expansion
Card" on page 115.
11
Connect all the cables to the system board.
12
Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 88.
13
Close the system. See "Closing the System" on page 86.
14
Place the system upright and on its feet on a flat, stable surface.
book.book Page 155 Monday, June 15, 2009 11:33 AM
