Dell T610 Manual

A SERVICE OF

next previous

Dell™ PowerEdge™ T610 Technical Guidebook

14

J. Fans

Two or four 92mm single‑rotor fans are in a module that is installed in the cooling shroud – fan

connectors blind mate into the planar when the cooling shroud is installed. Each fan has a single

wire harness that plugs into the planar fan connectors (FAN1 through FAN4). In a non‑redundant

conﬁguration, the two fans that need to be installed are the ones that are closest to the rear of the chassis

.

The iDRAC6 controls and monitors the speed of the fans. A fan speed fault or over‑temperature

condition results in a notiﬁcation by iDRAC6.

The PowerEdge T610 Power Supply Units have integrated fans. They are cooled by fans in the front

section. The system requires a blank module in place of the empty power supply slot.

All system fans are PWM fans. Redundant cooling (optional) is supported with one fan failing at a time.

Rails

 •Enablethereplacementofthumbscrewswithslamlatchesonthechassisforeasierstowingin

the rack.

 •Includethenew,simple,andintuitiveReadyRail™tool-lessrackinterfaceforsquare-holeand

round‑hole racks.

 •Providesignicantlyimprovedcompatibilitywithnon-Dellracks.

 •StaticrailsfortheR610&R710tinalltypesoffour-postandtwo-postracksavailableinthe

industry including four‑post threaded hole racks.

CMAs

 •ProvidemuchlargerventpatternforimprovedairowthroughtheCMA.

 •IncludeacommonsupporttrayforeliminatingCMAsag.

 •Replacedtiewrapswithhookandloopstrapstoeliminateriskofcabledamageduringcycling.

 •Maintainkeyfeatureofbeingfullyreversiblewithnoconversionrequired.