Operation
-14- Q-Wash 360Z-LED User Manual Rev. 01g
Menu Map
1
Level 2
Level 3
Level Description
INTRO
Selects a starting DMX address
Resets the fixture’s custom settings
FAN
Select the fan’s operation mode.
NOTE: The fan will go to High
mode if the fixture’s internal
temperature becomes too high, despite any manual or
DMX setting
RUN
Selects the first automatic program
Selects the second automatic program
Selects the user customizable program
Selects the Slave running mode
Starts the fixture’s test sequence
CHANNELS
Selects the 11-channel DMX mode
Selects the 15-channel DMX mode
DISPLAY
Turns off the display after 60 seconds
Activates/deactivates the control panel password
DIMMER
Slow (DIMMER4) to fast (DIMMER1) dimmer curves
Shows the version of the installed S/W
INVERT
NORMAL/
REVERSE
Defines the direction of the pan fader
Defines the direction of the tilt fader
Defines the direction of the dimmer fader
RANGE
000~255
Sets the pan start point (restricted range)
Sets the pan end point (restricted range)
Sets the tilt start point (restricted range)
Sets the tilt end point (restricted range)
SPECIAL
Activates the move-in black delay (3 s)
RESET
The DMX controller can reset the fixture
The control panel can reset the fixture
POWER
NORMAL/
HIGH
LEDs illuminate at normal or high intensity
NOTE: The fixture will return to Normal if the LEDs’
temperature becomes too high
COLOR
RGBW = 255: The output matches that of older fixtures
RGBW = 255: The RGBW output is set by RGB-W
RGBW = 255: The RGBW output is maximum
FAN
The DMX controller can set the fan speed
The control panel can reset the fan speed
EDIT
000~255
Selects the tilt position
Selects the pan/tilt speed
Combines red, green, blue, and white to obtain a custom
color
Continues on the next page
