Page 9SKU 97548 For technical questions, please call 1-800-444-3353.
Bottle Jack will not raise the Bottle Jack ram
when pumping the Handle manually.
Use the slotted end of the Handle to tighten 1.
(clockwise) the Release Valve Screw on the
Bottle Jack.
Bleed the Air Bottle Jack of excess air.2.
Bottle Jack will not raise the Bottle Jack ram
when using the pneumatic function.
Use the slotted end of the Handle to tighten 1.
(clockwise) the Release Valve Screw on the
Bottle Jack.
Check to make sure the regulator of the air 2.
compressor is set at 110-120 PSI.
Check for loose air connections and damaged 3.
air hoses.
Bleed the Bottle Jack of excess air.4.
Bottle Jack ram does not lower. Use the slotted end of the Handle to loosen 1.
(counterclockwise) the Release Valve Screw
on the Bottle Jack.
TROUBLESHOOTING
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
