Carrier
Press the UP button to
set the programmable
output for time based
operation. The digits in the
clock area will appear.
Page 14.3
Time-Based Control of the
Programmable Output
Time-Based Control of the
Programmable Output
To operate one of the MISC outputs using time-based operation, set
Advanced Setup step #30 (below) for Time i8:88. This extra output
will supply 24VAC to the selected MISC terminal, which is especially
useful for devices that require a start and stop time. Refer to page
14.4 - 14.5 for more details on programming this output.
Possible TIME scenarios:
1) An exterior lighting system that needs to be energized every
day between the hours of 8pm and 1am.
2) A sprinkler system that needs to be energized every day
between the hours of 2am and 4am.
Continued on
the next page
Press
MODE
PROGRAM
MODE
MODE
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the MODE
button to move back-
wards through the
setup screens.
OFF Time = Temp = Aux
I8:88
88
14
I8:88
Setup
30
