20 en | On-Screen Display Menu Navigation AutoDome 600 Series Analog PTZ Camera
F.01U.270.005 | 2.0 | 2012.06 User Manual Bosch Security Systems, Inc.
2.8 Rule Setup Menu
The Rule Setup Menu shows the status of the rules and lets you add new rules or modify an
existing rule. The default setting is Empty.
Rule Setup Menu Choices
Selecting a Rule number provides access to its configuration menu. The Rule # Menu allows
you to configure a rule from previously defined alarm inputs and outputs. Once an alarm is
configured with valid inputs and outputs, it can be turned on or off (enabled or disabled)
through its configuration menu.
NOTICE!
You can program a total of twelve rules. You must define the inputs and outputs before you
program a rule. See Section 2.7 Alarm I/O Setup, page 18, to configure alarm inputs and
outputs.
Rule Setup... Rule 1
Exit... Exit...
1. Rule 1 Enabled Enabled YES
2. Rule 2 Disabled Input:
3. Rule 3 Invalid NONE
4. Rule 4 Empty NONE
5. Rule 5 Empty NONE
6. Rule 6 Empty
7. Rule 7 Empty Output:
8. Rule 8 Empty OSD
9. Rule 9 Empty Shot 2
10. Rule 10 Empty Alarm Relay 2 sec
11. Rule 11 Empty NONE
12. Rule 12 Empty
4. Rule 4 Empty
Right / Left: Select Period Time
Focus / Iris: Select Focus / Iris: Select Type
Menu Description Sub-menu / Description Default
Setting
Exit Saves and exits the menu.
Rule 1-12 Displays the status of a rule
on the right side of the
menu. There are four (4)
possible rule statuses.
Enabled: The rule inputs and outputs are properly
defined and the rule is turned on.
Disabled: The rule inputs and outputs are defined but the
rule is turned off.
Invalid: The rule has a missing or invalid input or output.
Empty: The rule has no inputs or outputs defined.
Empty
