ServSwitch Wizard DVI/USB SRX
724-746-5500 | blackbox.com
Page 14
3.2.1.6 Power connections (optional)
The local module is designed to derive its power from the host computer via the USB connection (two connections for the dual
variant). If this is not possible, then you will need to use one or two optional Black Box power adapters.
1 Connect the output lead of the optional power adapter(s) to the socket(s) labeled ‘POWER‘ on the local module as shown in
Figures 3-11 and 3-12:
Figure 3-11. Attaching the power adapter connection to the single variant local module
Figure 3-12. Attaching the power adapter connections to the dual variant local module
2 Insert the IEC connector of the separate power cord(s) into the corresponding socket(s) of the power adapter(s). Connect the
other end of the power cord to one/two nearby mains socket(s).
Note: After all connections are made, power up the monitor and the REMOTE module first (followed by the LOCAL module, if
using the dual-variant with power adapters) and then switch on the computer.
Single-variant local module:
Use an optional power adapter
only if powering from the host
(via USB) is not possible.
Dual-variant local module: Use
two optional power adapters
only if powering from the host
(via dual USB connections ) is
not possible.
Do not use squid cables or
power splitters. Two separate
power adapters must be used.
