A SERVICE OF

logo

Page 20
724-746-5500 | blackbox.com
Appendix D: DDC Modes
Mode 3: To clone DDC from a display connected to the DVI output of the
receiver, remove jumper on J9, ensure J20 is in while transmitter is
powered off, then connect the display to the receiver and the receiver to
the transmitter and power everything on. Remove J20 while transmitter
is powered on and leave J9 off. The video source does not need to be
connected.
DDC mode
jumper
locations J20
and J9
Figure D-1. Jumper locations to change DDC mode.