Beko WMB 61221 M Manual

A SERVICE OF

next previous

14

EN

C

 Youcanremovethefiltercoverbyslightly

pushing downwards with a thin plastic tipped

tool,throughthegapabovethefiltercover.Do

not use metal tipped tools to remove the cover.

Some of our products have emergency draining hose

andsomedoesnothave.Followthestepsbelowto

discharge the water.

Dischargingthewaterwhentheproducthasan

emergency draining hose:

Pull the emergency draining hose out from its seat

Placealargecontainerattheendofthehose.Drain

thewaterintothecontainerbypullingouttheplugat

theendofthehose.Whenthecontainerisfull,block

theinletofthehosebyreplacingtheplug.Afterthe

containerisemptied,repeattheaboveprocedure

to drain the water in the machine completely. When

drainingofwaterisfinished,closetheendbythe

plug again and fix the hose in its place. Turn the

pump filter to take it out.

Dischargingthewaterwhentheproductdoesnot

have an emergency draining hose:

Place a large container in front of the filter to

catch water from the filter. Loosen pump filter

(anticlockwise) until water starts to flow. Fill the

flowing water into the container you have placed in

front of the filter. Always keep a piece of cloth handy

toabsorbanyspilledwater.Whenthewaterinside

the machine is finished, take out the filter completely

byturningit.Cleananyresiduesinsidethefilteras

wellasfibers,ifany,aroundthepumpimpellerregion.

Installthefilter.

A

 Ifyourproducthasawaterjetfeature,besure

to fit the filter into its housing in the pump.

Never force the filter while installing it into its

housing. Seat the filter into its place completely.

Otherwise,watermayleakfromthefiltercap.

Ifthefiltercapiscomposedoftwopieces,closethe

filtercapbypressingonthetab.Ifitisonepiece,seat

thetabsinthelowerpartintotheirplacesfirst,and

then press the upper part to close.